(Answer) (Category) Isuzu 4x4 Frequently Asked Questions : (Category) Axles : (Category) Isuzu Corporate 10 bolt :
Are there other differences between 10 bolt axles?
Moderator: houlster@inficad.com (inherited from parent)
The 10 bolt axle used in the rear remained pretty much consistant during it's use.

It has, however, been used in every 4wd Isuzu since around mid-'88. In the 2nd Gen vehicles that started in '98, the differential cage has undergone a slight change. The inside of the cage is slightly smaller and the LockRite locker will no longer fit it.

The 3rd member though is the same. A pre-'98 10 bolt diff can be bolted into a post-'98 3rd member so that a LockRite may be used. Or, the entire pre-'98 3rd member may be bolted into the post'-98 10 bolt (Xref) IFS housing.

Finally, around the '90 - '91 time frame, rear wheel (Xref) ABS was starting to be added to different models. This required a small change to the carrier and 3rd member housing. The carrier has a small ridge milled around the perimeter and a exciter ring is press-fit around the edge of the carrier. The ring gear prevents the exciter ring from backing off.

On the 3rd member housing, there was a boss added on the top of the pinion snout with a hole through it. A small sensor mounts here and extends down into the housing and senses the exciter ring as it turns. There were no changes to the ring gear to accomodate this, and you can physically swap (Xref) ABS with non-ABS 3rd members at will. Of course, you may loose (Xref) ABS functionality if you do so.

The (Xref) Isuzu Corporate 12 bolt exciter ring (very similar to the 10 bolt): (12-bolt_ABS_toner_ring.jpg)

houlster@inficad.com

[Append to This Answer]
Previous: (Answer) Is there a locker or limited slip available for this axle?
This document is: http://ifaq.houlster.com/cgi-bin/isuzu-faq?file=69
[Search] [Appearance]
This is a Faq-O-Matic 2.711.
This FAQ administered by houlster@inficad.com