|
|
Will I run into any problems installing a header? |
| Moderator: houlster@inficad.com (inherited from parent) | |
| There are a few issues that may cause problems depending on your vehicle, year and which header you're using.
First is the O2 sensor position. On the Calmini header, the O2 bung is much further down and rearward on the header than it was in the stock exhaust manifold. Some people have cut and soldered in extension wires in the O2 sensor harness to reach. It is possible though to un-wrap the vehicle wiring harness a ways and pull the O2 sensor wires out of it nearer to the firewall so that they will reach without cutting and soldering. This is the preferred method. Second is the EGR tube connection. Pre-93 2.6's used a screw in, flared fitting that the EGR tube screws in to and this is what these headers use as well. For '93 and newer 2.6's, Isuzu changed from this fitting to a 2 bolt flange. The brute force method of installing one of these headers on a '93+ is to make a matching 2-bolt flange and weld it to the header EGR tube connection bung. A better and more eloquent solution is to swap the EGR tube with one from a pre-'93 2.6. It is a pain to do as the bolts are hard to get to and get un-done, but the early EGR tube has been proven to fit the later 2.6's and matches up with the headers perfectly.
Third is that the header may interfere with the oil dipstick and tube. There are at least 2 different dipsticks used on the 2.6. Depending on your application, the dipstick may be in the way of the header. The dipstick tubes are not interchangable. The only way to get around this is to bend the dipstick tube. This is not a major deal, but care needs to be taken that you do not kink the tube and that the dipstick will still slide in and out of it freely. | |
| [Append to This Answer] |
| Previous: |
|
| Next: |
|
| ||||||||